Masonry Magazine June 2009 Page. 25

Words: Steve Cook, John Chrysler, Rick Swanson, Damian Lang, Craig Firl
Masonry Magazine June 2009 Page. 25

Masonry Magazine June 2009 Page. 25
Product Watch

Sioux Dakota II Series
Beresford, S.D.-based Sioux Corporation's Dakota II Series hot-water pressure washers and steam cleaners provide application specific, industrial cleaning solutions. The products feature rugged, steel frames. Fuel-fired burners offer efficient, consistent combustion, saving fuel and reducing emissions. A watertight NEMA 4 electrical enclosure keeps electrical components safe and dry, and adjustable digital temperature control is perfect for temperature-specific cleaning and sterilizing applications. The Dakota II Series is CETA performance tested and ETL/UL third-party approved. Learn more at www.sioux.com. IMAS

GETTING IN YOUR HOUSE OR CAR WITHOUT THE KEYS CAN BE TOUGH. Cleaning masonry architecture, new or old, without one or more of the three, simple keys to successful masonry cleaning can be devastating. The keys are: The correct cleaner, The proper personnel, The right equipment. Here are three cases where contractors, all of whom knew better, tried to get the job done without one or more of the keys.

Incorrect cleaner
IT WAS A MULTI-MILLION-DOLLAR luxury home on the north side of Chicago. The exterior was red brick and gray mortar except that the mortar joints weren't gray. They'd turned to an ugly yellow after new-construction cleaning in 2008 with muriatic acid. The raw acid had eaten away the cement paste, exposing yellow sand.

To cut costs, the mason contractor had forced the cleaning contractor - over the cleaning contractor's objections to use muriatic acid to remove excess mortar and common jobsite soiling.

The problem wasn't mere unsightliness, explains Jim Lucas, architectural consultant, J.N. Lucas and Associates, Hammond, Ind. The muriatic acid had eaten the joints to such an extent that they were no longer weather resistant.

Wrong equipment
AN ELEMENTARY SCHOOL in Akron, Ohio, with a concrete brick exterior, looked fine after its new-construction cleaning in 2007- for about three weeks. That's when the rich, deep red of the concrete brick faded to a dull, listless pink. To save time, the contractor had applied the cleaner at pressures six- to eight-times the manufacturer's recommended maximum.

The high pressure jammed the cleaner into the concrete brick pores to a depth of 1/8- to 1/4-inch, says Mike Trotta, contractor training specialist for PROSOCO in Lawrence, Kan. That was too deep for rinse water to flush out. Later, as the embedded cleaner effloresced out of the brick, it faded the color. Though the concrete brick, a good product, was not to blame, it's now banned from the Akron school system, Trotta says.

OPPOSITE PAGE CLOCKWISE FROM TOP: Project Foreman Eduardo Erazo, Sparklewash Construction Services. Omaha. Neb., uses the comect equipment to apply an appropriate masonry cleaner to clay brick and precast concrete at the Bank of West Omaha. This photo shows why you should always test before overall cleaning. Here, a contractor tested a cleaner made for clay brick on concrete brick. Project Foreman Eduardo Erazo, Sparklewash Construction Services, Omaha, Neb, thoroughly flushes spent cleaner and dissolved contaminants from limestone after new-construction cleaning at the Bank of West Omaha.

Personnel problem
A STRIP MALL in Wausau, Wis, looked great, on three sides. The clay brick front and split-face block sides all looked terrific after post-construction cleaning in 2008. But the rear of the building, also split-face block, was scarred with wand marks.

The project superintendant explained what happened, Lucas says. Though the super had cleaned the building's sides personally, he'd let an inexperienced apprentice clean the back without proper supervision. Wand marks resulted.

In this case, and the other two, the damage was at least partly reversed. But the cost in time, money, reputation and aggravation could have-and should have been avoided altogether.

Masonry Cleaning Systems
Kem-O-Kleen
Fast Consistent Thorough
For Cleaning New Masonry
& Masonry Restoration
Proven & advanced over 35 years
Save labor and chemicals - fast payback
Superior results
Quick cleaning on your schedule
Visit us at www.kem-o-kleen.com
or call toll free 800-274-4121
See us at World of Concrete Booth $12751


Built to Endure: Exploring the All-Weather Strength and Longevity of Manufactured Stone Veneer
April 2025

Let's talk about something we all care deeply about: the longevity of our work. You and I both know the feeling of pride when we step back and look at a finished project. We're in the business of creating structures that not only look good but also stand

Preparing Masonry Jobsites for Summer Weather
April 2025

Spring is in the air, and summer is right around the corner. With that in mind, it’s time for all of us in the masonry industry to start preparing for warmer weather. It is very important that we consider the risks associated with working in the summer he

Meet the Next (Fourth!) Generation at PROSOCO
April 2025

After 12 years in different roles at PROSOCO, Jake Boyer will become President of the family-owned company on June 6. Most family-owned businesses don’t make it to the second generation, let alone the third or fourth. According to recent data, only 3% of

Tips For Maintaining A Jobsite
April 2025

Jobsite Maintenance is not something that many people like to talk about. Most people want to know when the job is going to start. What is the lead time to get the material that is specified? Who is the general contractor, and are they good to deal with?